Startup System Programming
|
1
|
To check your system's software level:
- When your telephone is idle, press INTERCOM.
- Dial #*#*.
- The system software level shows on the first line of your
display.
- For example, for DSX-40 version 3.01 you see:
DSX-40 Version 3.01
- Press SPEAKER to exit.
|
2
|
Enter the programming mode.
- From any display telephone:
- Press INTERCOM + Dial
#*#*.
- Enter the system password + HOLD.
- The system passwords are:
- 632379 (NECDSX) for Installer (level 3).
- 9999 for System Administrator 2 (level
2).
- 0000 for System Administrator 1 (level
1).
- See System Programming Password Protection
for more.
|
3
|
Assign the correct circuit type to each of your installed lines.
- In 3101-01: Line Type [Lines: Config: Setup: Type (3101): Type], assign the correct
circuit type for each line. Analog line types are:
- 51 for loop start DTMF
- 52 for loop start DP
|
4
|
By default, each extension has full incoming and outgoing access to each line.
- To change this assignment, in 2131-[01-64]: Line Access Stations: Config: Line Access: Line Access (2131): Line Access] change each
extension's line access as required:
- 0 for no access
- 1 for incoming access only
- 2 for outgoing access only
- 3 for full access
- Using 9021-01: Station Copy [See the Tool Bar] may save you
time.
|
5
|
By default, extensions 301-316 ring immediately day and night for on lines 1-12.
- In 2132-[01-64]: Line Ringing Stations: Config: Ring Assign: Line Ringing (2132): Ring Assignment], set the ringing
option for each extension.
- 0 for lamp only (no ringing) day and
night.
- 1 for day and night ringing.
- 2 for night ringing only.
- 3 for delay ringing day and night.
- Using 9021-01: Station Copy [See the Tool Bar] may save you
time.
|
6
|
To change the default system passwords:
- Turn to System Programming Password Protection.
|
7
|
To return the system to the factory installed (default) programming:
- Turn to 9011-01: System Initialization [Utilities: Initialize: System].
|