Programming Outgoing Calling Party Number (CPN)

Additional Feature Information
Primary Rate Interface (PRI)
Direct Inward Dialing
T1 Lines
Programming for this Feature
Programming PRI Basics
Programming Incoming Calling Party Number and Name

Setting Up Outgoing Calling Party Number

1. Set the options for outgoing CPN.

  1. 1011-02: Telephone Number [System: Config: Setup: Name (1011): Phone Number]
    Program the system’s Outgoing Calling Party Number.
    This will be the Outgoing Calling Party Number unless overwritten by the line or extension programming in the following steps.
    Option Description
    Digits Digits (18 digits max. using 0-9, # and *). [Default] = no entry.
  2. 3101-07: Telephone Number [Lines: Config: Setup: Type (3101): Phone Number]
    Program the Outgoing Calling Party Number for each PRI line.
    Each line can have a unique number.
    This will be the Outgoing Calling Party number for all calls on the line unless modified by extension programming in the next step.
    Option Description
    Digits Digits (18 digits max. using 0-9, # and *). [Default] = no entry.
  3. 2101-05: Outgoing ANI ID [Stations: Config: Setup: Type (2101): ANI ID]
    [3.01] Program the Outgoing Calling Party Number for each extension (up to 18 digits).
    [3.01] For PRI calls, this option specifies the number that will replace the system or line number.
    Option Description
    Digits [3.01] Digits (18 digits max., using 0-9, # and *). [Default] = no entry.

2. Optionally enable Outgoing Calling Party Number Privacy.

  1. The system will mark outgoing PRI calls from extensions with this capability as private and will not display an outgoing number.
  2. Normally, outgoing calls from the extension will be received as Private Number.
  3. 1404-05: Ongoing ANI Privacy [System: Class of Service: Caller ID: Caller ID (1404): Outgoing ANI Privacy]
    Use this option to enable Outgoing Calling Party Number Privacy
    Option Description
    No (0) [Default] Disabled.
    Yes (1) Enabled.
  4. 2102-01: Class of Service [Stations: Config: Setup: Access (2102): Class of Service]
    Assign Class of Service to extensions.
    Option Description


    1-15
                                                


    Class of Service level 1-15.
    [Default] for extension 300 = 1.
    [Default] for all other extensions = 2.